Thank you for choosing Rough Country for all your suspension needs. Rough Country recommends a certified technician install this system. In addition
42. Install the spacer on strut using stock hardware using 15mm wrench. See Photo 37. 43. Install strut onto truck using 14mm wrench to tighten upper
49. Notch a section of the stock mount to remove the brake line as shown in Photo 43 and remove line from housing. Straighten bends in hard metal line
55. Slide the axle in the bearing assembly and install the knuckle on the upper ball joint using a 21mm and 10mm wrench. See Photo 49. 56. Tighten the
1. Remove wheels using a 22mm socket. 2. Remove ABS clip from axle. See Photo 1. 3. Remove the brake line as shown in Photo 2 using 13mm. 4. Remo
8. Remove upper track bar bolt using 21mm wrench. See Photo 7. 9. Remove the vent hose from axle. 10. Remove coil springs. See Photo 8. 11. Install
15. Install bushing a sleeves into shocks. Install shock onto truck using stock hardware with new flag nut for top bolt. See Photo 18. 2.2 Shock A
21. Install track bar into bracket with stock bolt. You may have to do this with truck on the ground. Tighten upper bolt using 22mm wrench and lower w
CUTTING TEMPLATE
CUTTING TEMPLATE
KIT CONTENTS 1326Box1 Containing: 1-Fr Cross-member (A) 1-Rr Cross-member (B) 1324Box2 Containing: 1-Dr Fr Diff Brkt (C) 1-Dr Rr Diff Brkt (D)
KIT CONTENTS A B C D E F G H I L J K M O O P P Q Q Thank You for choosing Rough Country for your off road needs!!! R R V V S L M N N
1. Chock rear wheels of the vehicle and raise the front of the vehicle using a floor jack. 2. Support the vehicle with jack stands. 3. Remove wheel
11. Remove lower strut mount using 21mm and 24 mm wrench. See Photo 7. 12. Remove sway-bar link from sway-bar using 16mm wrench. See Photo 8. 13. Rem
17. Remove the two upper diff bolt from the motor mount / diff mount using 18mm socket. Retain the stock hardware . See Photo 13. 18. Remove rear cros
23. Align the supplied template with the lower holes. Tape cut out to driver side lower control arm rear pocket. 24. Cut at the line on the cut out.
29. Secure the driver side differential to the frame using the supplied 12mm x 45mm bolts, flat washers, and flange lock nuts. See Photo 25. 30. Secu
36. Install lower control arm using stock cam bolts. See Photo 31. 37. Install skid plate using supplied 3/8” X 1” bolts and 3/8” washers on the fro
Commentaires sur ces manuels