Rough-country 7544 Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

1. With the truck parked on a clean, dry, and level surface set the parking brake. Chock the rear wheels. Using a floor

jack raise the front of the truck and support the frame rail with approved jack stands. NEVER WORK UNDER AN

UNSUPPORTED VEHICLE.

2. Using a 22 mm socket remove the lug nuts on the front wheels and remove the front wheels.

3. Measure the amount of thread showing on the torsion bar adjuster bolts. See Photo 1. Drivers Side ______

Passenger Side ______ Using a 18mm socket remove the adjuster bolt

4. Remove the shock absorbers using a XX wrench. Retain factory hardware for reuse.

5. Using a Ford approved torsion bar tool as shown in Photo 2 to relieve the pressure from the adjuster bolt and

treaded adjuster block. See Photo 2.

92754400

97-03 FORD TORSION BAR KEYS

Thank you for choosing Rough Country for your suspension needs.

Rough Country recommends a certified technician install this product.

Please read instructions before beginning in-

stallation.

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of

the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-

cle of its unique handling characteristics.

We hope installing your Rough Country lift kit is a positive experience. If you are uncertain about some aspect

of the installation process, please feel free to call our tech support department at 800-222-7023. We do not rec-

ommend that you modify the Rough Country parts in any way as this will void any warranty expressed or im-

plied.

Photo 1 Photo 2

Tools Needed:

18mm Socket / Wrench

21mm Socket/ Wrench

22mm Socket / Wrench

1 2

INSTALLATION INSTRUCTIONS 1. With the truck parked on a clean, dry, and level surface set the parking brake. Chock the rear wheels. Using a floor

Page 2

POST INSTALLATION INSTRUCTIONS 1. Lug nuts should be check after 50 miles and all nuts and bolts should be checked and tightened after 500 miles. A

Pas de commentaire

Rough-country 7544 Manuel d'utilisateur