09-UP FORD F150 6” LIFT KIT THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR SUSPENSION NEEDS. Rough Country recommends a certified technician install
52. Using the stock hardware, install the strut spacers on the struts. Tighten using a 15mm socket. See Photo 43. 53. Install the strut with strut spa
60. Install the new knuckles using the stock hardware on the lower ball joints, making sure the half shafts are installed in the bearing assembly. Ti
REAR INSTALLATION 1. Chock the front tires and jack the rear the rear end up. Put jack stand under the frame rail and lower truck onto jack stands.
8. To install the new e-brake bracket measure from the rear measure 1 5/8” and from the bottom measure up 1 3/8” and mark hole to be drilled. See Pho
THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR SUSPENSION NEEDS 14. Install the upper leaf spring u-bolts on leaf spring and blocks. Secure with
CUTTING / DRILLING TEMPLATE—FR SIDE OF DRIVER CROSS-MEMBER CUT LINE
CUTTING / DRILLING TEMPLATE—REAR OF DRIVER SIDE CROSS-MEMBER CUT LINE DRILL
KIT CONTENTS Bag1 Continued: For Rr / RrCross-Member: 2-18mm x 160mm Bolts 4-18mm Flat Washers 2-18mm Lock Nuts For Fr Drivers Side Diff Moun
INSTALLATION INSTRUCTIONS 1. Chock the rear wheels and jack up the front of the vehicle. 2. Place jack stands under the frame rails and lower onto
9. Remove the dust shield using a 8mm socket and dust cap. See Photo 7. 10. Remove the ABS wire from the bearing assembly using a 5mm allen wrench. S
16. Remove the lower strut bolt using a 30mm socket and 1 –1/16” wrench. See Photo 13. Retain hardware for reuse. 17. Remove the sway bar from the fra
22. Remove the stock rear cross-member using a 15mm & 18mm socket. Retain hardware for reuse. See Photo 19. 23. Tape supplied cutting template on
29. Install the upper differential drop bracket on the driver side using the stock hardware. See Photo 25. Do not tighten at this time. 30. Install th
35. Install the supplied 9/16” x 4 1/2” rear differential bolt through the sway bar mount and new differential mount. See Photo 31. Do not tighten at
44. Install the drive shaft spacer with supplied 10mm x 80mm hardware. See Photo 37. Tighten using a 8mm allen wrench. 45. Using a 10mm wrench remove
Commentaires sur ces manuels