Rough-country 1011 Manuel d'utilisateur télécharger pdf

JEEP TJ /YJ BUMPER

Thank you for choosing Rough Country

Please read instructions before beginning installation. Check the kit hardware against the parts list and product layout.

Be sure you have all needed parts and know where they go. Also please review tools needed list and make sure you

have needed tools.

If question exist we will be happy to answer any questions concerning the design, function, and cor-

rect use of this product.

The installer must verify that the mounting kit does not interfere with the factory air bag sensors, which must not be relo-

cated or modified in any way. The vehicles are bag system may not operate properly if the winch mounting kit is not

mounted in compliance with the vehicle manufacturers recommendations.

As with the addition of any aftermarket bumper, the air bag system will be affected and may hinder or delay deployment.

Take this into consideration and drive accordingly.

INSTALLATION

1. Place vehicle on a flat surface and set emergency brake.

2. Remove the front valence (sway bar cover), using a 3/8” wrench. See PHOTO 1

3. Using a T55 torx socket, remove the front bumper mounting hardware and tow hooks if equipped.

4. Using a 15mm socket remove the front stabilizer mounting bolts. (TJ ONLY)

5. If installing a winch at this time it is recommended that you install the winch to the mounting plate, before installing

the plate on the vehicle.

6. Place the supplied washers as shown in PHOTO 2 on TJ models. YJ models will not use these washers.

92101100

PHOTO 1

REMOVE THE SWAY BAR COVER ON TJ

PHOTO 2

PLACE WASHERS ON FRAME (TJ SHOWN)

Optional

Accessories:

Light Bar- #1014

Stinger #1013

D-Ring Mount-#1058

Kit Contents:

1– Mounting Plate

1– 1012Bag2 including:

4– Large Thick Washers

4- 1/2” x 1 1/2” Bolt

4– 1/2” Flat Washers

12-1/2” x 1 1/2” Button Head Bolts

4-1/2” Lock Nuts

2-10mm x 40mm Bolts

2-10mm Flat Washers

Tools Needed:

T55 Torx bit

3/8” Wrench

17mm Socket

3/4” Wrench

8mm Allen Wrench / Bit

1 2 3 4

Résumé du contenu

Page 1 - JEEP TJ /YJ BUMPER

JEEP TJ /YJ BUMPER Thank you for choosing Rough Country Please read instructions before beginning installation. Check the kit hardware against the p

Page 2

7. Place winch mounting plate in position and align the mounting holes on the plate with the holes on the frame. See PHOTO 3. 8. Install the supplie

Page 3

PHOTO 1 PHOTO 2 1. On the TJ the front sway bar cover can be replaced with some trimming, if you elect to keep the cover see PHOTO 1 and 2 for requir

Page 4 - BUMPER ACCESSORIES

THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR OFF ROAD NEEDS. PART # 1056 D-RING KIT PART # 1014 LIGHT BAR/ WINCH GUARD PART # 1013 STINGER KIT BUMPER

Commentaires sur ces manuels

Pas de commentaire

Rough-country 1011 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rough-country 1011. Rough Country 1011 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rough-country 1011