Rough-country 774S Manuel d'utilisateur

Thank you for choosing Rough Country for all your suspension needs. This kit will fit both 4WD and 2WD models, all brackets will be used for 4WD mode

8. Install the shock on the lower shock mount with factory hardware and tighten using a 17mm wrench. Note: The RCX 2.2 Series Shock Absorber is desig

Kit Contents: 1775Box1: Front Cross-member Rear Cross-member Sway Bar Drop Bracket (2) Dr Side Steering Stop Pass Side Steering Stop 177

1. Park the vehicle on a level surface and chock the rear wheels. 2. Jack up the front of the vehicle and place jack stands under the frame rails.

8. Remove the dust shield and remove cotter key from axle and remove axle nut (4WD Model) using a 39mm socket as shown in Photo 7. 9. Remove cotter

17. Swap left and right outer tie-rod ends as shown in Photo 13. This is done for wheel clearance. 18. Trim rear lower control arm pocket front side o

25. Install bushing into passenger side diff bracket. Using 2- 9/16 x 4” long bolts and 21 and 22mm wrench on vehicle. Use stock bolts for bracket to

31. Install the strut spacer on the strut with the factory hardware. Tighten using a 14mm wrench. See Photo 25. 32. Install the 3/8 studs into strut e

41. Install the stock brake line bracket onto the knuckle as shown in Photo 31 using the stock hardware. Tighten using 12mm wrench. 42. Install the

1. Chock the front tires. Jack up the rear of the vehicle and place jack stands under the frame rails, remember to raise the rear high enough so the