Thank you for choosing Rough Country for all your suspension needs. Rough Country recommends a certified technician install this system. In addition
49. Notch a section of the stock mount to remove the brake line as shown in Photo 43 and remove line from housing. Straighten bends in hard metal line
54. Slide the axle in the bearing assembly and install the knuckle on the upper ball joint using a 21mm and 10mm wrench. See Photo 49. 55. Tighten the
1. Chock the front tires and place the rear on jack stands. Lightly support the axle with a floor jack. 2. Remove the shocks from the axle using 21m
CUTTING TEMPLATE
CUTTING TEMPLATE
Thank You for choosing Rough Country for your off road needs!!! POST INSTALLATION 1. Check all fasteners for proper torque. Check to ensure there i
KIT CONTENTS 1326Box1 Containing: 1-Fr Cross-member (A) 1-Rr Cross-member (B) 1326Box2 Containing: 1-Dr Fr Diff Brkt (C) 1-Dr Rr Diff Brkt (D)
1. Chock rear wheels of the vehicle and raise the front of the vehicle using a floor jack. 2. Support the vehicle with jack stands. 3. Remove wheel
11. Remove lower strut mount using 21mm and 24 mm wrench. See Photo 7. 12. Remove sway-bar link from sway-bar using 16mm wrench. See Photo 8. 13. Rem
18. Remove the two upper diff bolts from the motor mount / diff mount using 18mm socket. These bolt can be very hard to access. Also the diff mount ma
23. Align the supplied template with the lower holes. Tape cut out to driver side lower control arm rear pocket. 24. Cut at the line on the cut out.
28. Install passenger side diff bracket using stock hardware in upper location if motor mount is threaded . If not use sup-plied 12mm x 65mm bolts for
35. Install lower control arm using stock cam bolts. See Photo 31. 36. Install skid plate using supplied 3/8” X 1” bolts and 3/8” washers on the fro
41. Install the spacer on strut using stock hardware using 15mm wrench. See Photo 37. 42. Install strut onto truck using 14mm wrench to tighten upper
Commentaires sur ces manuels