Rough-country 257.20 Manuel d'utilisateur

Thank you for choosing Rough Country for your suspension needs. Rough Country recommends a certified technician install this system. In addition to

CAB INSTALLATION INSTRUCTIONS 1. Raise hood disconnect positive and negative battery cable from the battery using 10mm wrench. This is done to preve

10. Remove upper radiator hose and overflow hose from fan shroud as shown in Photo 7 & 8. 11. Disconnect air intake hose from air box using a Phil

LOOSEN FRAME END OF STRAP 15. Disconnect the emergency brake cable at the connection on the frame below the drivers door by removing the front part of

19. Lift only enough to place body puck on top of body mount. See Photo 19. Note: Passenger side front body mount bolt can be removed by lifting the b

31. Find the tab on driver side body mount where the emergency brake cable runs beside it and bend it up flat with frame to gain slack for cable. See

38. Install tow hooks so that they are upside down and install stock bolts. Tighten to 65ft-lbs using a 18mm wrench / socket. See Photo 31. 39. Insta

1. Unplug the license plate light connector and if equipped the trailer wiring connector. See Photo 1 & 2. 2. Remove the 3 bolts from the driver

5. Loosen the six bed bolts using 18mm socket but only remove one side at a time. See Photo 6, 7 & 8. 6. With jack stand or hydraulic jack and w

8. With bumper still removed, use the supplied template to mark and drill the new holes in the frame. See Photo 13. 9. Drill the holes using a 1/2”

PHOTO 19 INSTALL THE 14MM X 60MM BOLTS POST INSTALLATION INSTRUCTIONS 1. Check all fasteners for proper torque. Check to ensure for adequate cleara

FRONT INSTALLATION 1. Park the vehicle on a level surface and chock the rear wheels. 2. Jack up the front of the vehicle. Place jack stands under t

REAR BUMPER DRILLING TEMPLATE

10. Mark location of alignment cams on upper control arms to allow installation of new arm to same position. Using a 21mm wrench and 21mm socket, re

17. On the Drivers side, locate and secure the new diff mount drop bracket to the stock location using the supplied 12mm x 45mm socket head bolts. Ti

27. Install the strut spacer on the factory strut with factory hardware and using a 18mm wrench. See Photo 20. 28. Install the strut assembly in the

REAR INSTALLATION 1. Chock the front wheels. 2. Place a floor jack under the differential and jack up the rear of the vehicle. 3. Place jack stand

Box Kit 1-Driver Side Control Arm 1-Pass Side Control Arm 1-Driver Side Diff Bracket 1-Pass Side Diff Bracket 1-Diff Lower Skid Plate

Thank you for choosing Rough Country for your suspension needs. KIT CONTENT Dr. upper Control arm Strut spacers Pass. Upper control arm Lower skid pl

07-11 GM 4WD 1500 P/U 1 1/4” Body Lift Thank you for choosing Rough Country for all your suspension needs. Rough Country recommends a certified techn