Rough-country 253X Manuel d'utilisateur télécharger pdf (Page 8)

33. Install the rear driver differential bracket using stock bolt with supplied 12MM flange lock nut. Slightly tighten using a

18MM wrench Do not fully tighten at this time. See Photo 25.

34. Apply thread lock to the two 12mm x 35mm bolts and install the passenger differential on the brackets with the sup-

plied 12mm flat washers using stock nuts in 1253Bag3. Tighten using a 19mm and 21mm wrench. See Photo 26.

35. Install the differential on the drivers side to the brackets with the stock bolts and supplied 12mm flange lock nuts

from 1253Bag3 in the forward two holes. See Photo 27. Tighten using a 15mm & 18mm wrench.

36. On the rear driver mount install the supplied 12mm x 35mm bolt and flat washer from 1253Bag3. See Photo 28.

Tighten bolt using a 18mm wrench.

37. Tighten the drop bracket to frame mount bolts using a 18mm socket / wrench.

38. Reattach the differential wires and vent tube to the axle. It may be necessary to pull some slack from top. Do Not pull

on the wiring connector as damage to the wires can occur.

39. Reinstall front drive shaft using the factory hardware. Tighten using a 11mm socket.

40. Install rear cross-member using the supplied 18mm x 140mm bolts, flat washers and lock nuts in 1253Bag2. Tighten

using a 27mm socket/ wrench. See Photo 29.

41. Install the two stock bolts in the stock location and tighten using a 18mm socket / wrench.

42. Install front cross-member using the supplied 18mm x 120mm bolts, flat washers and lock nuts in 1253Bag2. See

Photo 30.

Photo 25

Photo 26

Photo 27

Photo 28

Photo 29

Photo 30

INSTALL DRIVER SIDE REAR DIFF BRACKET

REINSTALL DIFFERENTIAL ON PASS SIDE

REINSTALL DIFFERENTIAL ON DRIVER SIDE INSTALL DIFF ON DRIVER SIDE REAR BRCKT

INSTALL REAR CROSS-MEMBER

INSTALL FRONT CROSS-MEMBER

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Rough-country 253X Manuel d'utilisateur Page 8