Rough-country 5061 Manuel d'utilisateur télécharger pdf

Page 1

Thank you for choosing Rough Country Off Road Gear for your suspension needs.

Rough Country recommends a certified technician install this system. In addition to these instructions, professional

knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to

install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the

vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you

have all needed parts and know where they go.

With the installation of all lift kits and larger tires it is important to check the condition of your steering stabilizer. If

the stabilizer is worn or is leaking it should be replaced. Steering stabilizers are designed to restrain “bump

steering” and front end vibration, giving added life to tires, ball joints, and other steering components.

PRODUCT USE INFORMATION

Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height

of the Rough Country product purchased. Mixing component brands is not recommended.

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be

responsible for any product that is altered.

If question exist we will be happy to answer any questions concerning the design, function, and correct use of our

products.

Installation time for this kit is 2-3 hours

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the

inside of the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is

operating the vehicle of its unique handling characteristics.

INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation

instructions on to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.

IMPORTANT NOTICE

This bracket kit is not

designed to be a lift kit. It’s designed to relocate the front spring shackle point from the front

of the spring to the rear, vastly improving ride quality. Before starting, verify that your vehicles frame is straight and

in alignment. Also, check frame rails for cracks and or heavy rust. Only install this system on vehicles in good

sound shape.

With the installation of this kit the front driveshaft will pull out slightly revealing more of the drive shaft. This is

common and necessary for the Jeep to function properly. The normal operating travel of the front end with this kit

has been changed to swing rearward instead of front ward. The driveshaft length should not be changed. If a new

driveshaft is desired, the new shaft must be stock length or run the risk of a longer shaft bottoming out and

impacting the transfer case.

92506100 REV B

5061 YJ Wrangler Shackle Inversion

1 2 3

92506100 REV B 1
INSTRUCTION SHEET 2

Résumé du contenu

Page 1 - 92506100 REV B

Page 1 Thank you for choosing Rough Country Off Road Gear for your suspension needs. Rough Country recommends a certi

Page 2 - INSTRUCTION SHEET

INSTRUCTION SHEET Technical Assistance - (731) 285-9000 Page 2 RECOMMENDED TOOLS • Pry Bar • T55 socket • Safety glasses • Wheel chocks • Floor

Page 3

INSTRUCTION SHEET Technical Assistance - (731) 285-9000 Page 3 5. Install the leaf spring in the new bracket with the factory bolt. See Photo #

Commentaires sur ces manuels

Pas de commentaire

Rough-country 5061 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rough-country 5061. Rough Country 5061 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rough-country 5061